Your Garage Floor Is Holding Five Years Of Oil, Salt, And Brake Dust. We Strip It In One Pass.
Calgary winters drag salt and slush into your garage every drive home. After a few seasons, the floor turns grey, sticky, and porous. One professional cleaning resets it — and protects the concrete from long-term damage.
WhatsApp a Photo for Instant Quote
Hot Water, Degreaser, Surface Cleaner. That's What It Takes.
Why DIY Garage Cleaning Fails
Cold-water consumer-grade pressure washers can't break down petroleum residue, brake dust, or set-in chloride salt. We bring commercial hot-water units and a degreaser pre-treatment that emulsifies oil at the molecular level. Then a surface cleaner pass evens out the result — no streaks, no missed corners. The water we generate is captured and directed to the driveway exit, not blasted onto your neighbour's car.
Most 2-car Calgary garages are done in 60–90 minutes including pre-treatment, surface clean, and rinse. Epoxy-coated floors: we adjust to lower pressure and use a hot-water-only approach — safe for the coating.
- Hot-water unit lifts petroleum, brake dust, salt
- Degreaser pre-treatment for old oil stains
- Surface cleaner pass — no streaks, no missed spots
- Epoxy-coating safe technique (we ask first)
- Water managed with squeegees & shop vacs, not blasted
Questions Calgary homeowners ask before booking
How much does garage floor cleaning cost in Calgary?
Most 2-car garages start at $120. 3-car and oversized $150–$200. Includes degreaser pre-treatment and surface cleaner pass.
Can you remove old oil and brake-dust stains?
Most of them, yes. We pre-treat with degreaser and run a surface cleaner. Stains older than 2–3 years may leave a shadow — we'll show you a test patch before committing.
How long does it take?
Most garages are done in 60–90 minutes including pre-treatment and rinse.
Do you handle the water? Where does it drain?
We bring squeegees and shop vacs to control runoff. For garages without a floor drain, we direct water to the driveway exit.
Is it safe for epoxy-coated floors?
Yes — we adjust pressure and tip for epoxy. Hot-water and surface cleaner only, no aggressive direct nozzle.